The Nissan Altima, 6th generation (L34), lists these tire sizes in the manual: P215/60R16, P215/55R17 and P235/40R19. Lug nut torque is 83 lb-ft. The manual gives no pressure number; it sends you to the door placard.
The 2020 Altima manual does something a lot of owner's manuals skip: it ties each tire size to a trim. The 2.5 S wears P215/60R16, the 2.5 SV and SL wear P215/55R17, and the SR and Platinum cars (2.5 and 2.0) wear P235/40R19. What it does not do in its specifications is print a psi number, so that part lives on the car.
Nissan Altima specs, by the manual
| Spec | Value | Applies to | Source |
|---|---|---|---|
| Tire size | P215/60R16 | 2.5 S model | p. 10-10 |
| Tire size | P215/55R17 | 2.5 SV and SL models | p. 10-10 |
| Tire size | P235/40R19 | 2.5 and 2.0 SR and Platinum models | p. 10-10 |
| Cold pressure | On the placard, no number in the manual | The Tire Load and Information label on the driver side center pillar. The manual does not print a psi number in its specifications. | p. 6-8 |
| Wheel size | 16x7.0J | Steel, offset 1.77 in (45 mm) | p. 10-10 |
| Wheel size | 17x7.5J | Aluminum, offset 1.97 in (50 mm) | p. 10-10 |
| Wheel size | 19x8.0J | Aluminum, offset 2.17 in (55 mm) | p. 10-10 |
| Lug nut torque | 83 lb-ft | Printed as 83 ft-lb (113 N-m). | p. 6-8 |
| Spare | Temporary spare on a 16 x 4T wheel (offset 1.18 in, 30 mm). The page lists both T135/70D16 and T135/90D16 and does not say which applies where. | All | p. 10-10 |
| TPMS | Direct (sensors) | The manual says the system monitors every tire except the spare by sending a signal from a sensor installed in each wheel. | p. 6-3 |
Compare this lug nut torque with other vehicles in the lug nut torque chart.
Compare this tire pressure with other vehicles in the tire pressure chart.
Compare these tire sizes with other vehicles in the tire size chart.
Exceptions the manual documents
2.5 and 2.0 SR and Platinum models
P235/40R19 tires, where the 2.5 S uses P215/60R16 and the 2.5 SV and SL use P215/55R17. (p. 10-10)
Engine-specific rotation interval
Rotate every 5,000 miles (8,000 km) on the PR25DD engine and every 7,500 miles (12,000 km) on the KR25DDET engine. (p. 9-3)
All models
Tire chains go on the front wheels only, never on the temporary spare. (p. 8-37)
Reading these numbers
Pressure sits on the Tire Load and Information label on the driver side center pillar, and the manual says the same label is the reference for cold pressures when you change a tire. Cold means the car has been parked for a while, so check before you drive, not after.
Wheel offset climbs with diameter in Nissan's table: 1.77 in (45 mm) on the steel 16 x 7.0J, 1.97 in (50 mm) on the aluminum 17 x 7.5J, and 2.17 in (55 mm) on the aluminum 19 x 8.0J. If you are shopping for aftermarket wheels, those three numbers are the factory reference, not a recommendation.
Rotation is the odd one out. The maintenance page gives 5,000 miles (8,000 km) for the PR25DD engine and 7,500 miles (12,000 km) for the engine it calls KR25DDET, so the turbo car and the plain 2.5 do not share a schedule. The monitor is a sensor in each wheel, and it does not watch the spare. Chains, if you use them, go on the front wheels only.
Sources
Every number above is quoted from the documents below. Each source entry was last checked against its manual on 2026-10-23.
2020 Nissan Altima Owner's Manual, page 10-10
Printing: August 2019, Publication No. SU20EA 0T32U0. Last checked against the manual on 2026-10-23.
"WHEELS AND TIRES Wheel type Size Offset in (mm) Steel 16 x 7.0J 1.77 (45) Aluminum 17 x 7.5J 1.97 (50) Aluminum 19 x 8.0J 2.17 (55) T-type (Steel spare) 16 x 4T 1.18 (30) Tire size 2.5 S model P215/60R16 2.5 SV/SL models P215/55R17 2.5 and 2.0 SR/Platinum models P235/40R19 Spare tire Temporary T135/70D16 Temporary T135/90D16"
2020 Nissan Altima Owner's Manual, page 6-8
Printing: August 2019, Publication No. SU20EA 0T32U0. Last checked against the manual on 2026-10-23.
"Wheel nut tightening torque: 83 ft-lb (113 N·m) [...] COLD tire pressures are shown on the Tire Load and Information label affixed to the driver side center pillar."
2020 Nissan Altima Owner's Manual, page 6-3
Printing: August 2019, Publication No. SU20EA 0T32U0. Last checked against the manual on 2026-10-23.
"It monitors tire pressure of all tires except the spare. [...] by sending a signal from a sensor that is installed in each wheel."
2020 Nissan Altima Owner's Manual, page 9-3
Printing: August 2019, Publication No. SU20EA 0T32U0. Last checked against the manual on 2026-10-23.
"Tire rotation*: PR25DD Engine model; Tires should be rotated every 5,000 miles (8,000 km). KR25DDET Engine Model; Tires should be rotated every 7,500 miles (12,000 km)."
2020 Nissan Altima Owner's Manual, page 8-37
Printing: August 2019, Publication No. SU20EA 0T32U0. Last checked against the manual on 2026-10-23.
"Tire chains must be installed only on the front wheels and not on the rear wheels. Never install tire chains on a TEMPORARY USE ONLY spare tire."
Frequently asked
What tire size does a 2020 Nissan Altima use?
Nissan lists P215/60R16 for the 2.5 S, P215/55R17 for the 2.5 SV and SL, and P235/40R19 for the 2.5 and 2.0 SR and Platinum. The sidewall on your tire shows what is on your car now, and your own owner's manual is the final word.
What is the lug nut torque for a Nissan Altima?
The 2020 manual prints 83 ft-lb (113 N-m), which is 83 lb-ft.
Where do I find the Altima tire pressure?
On the Tire Load and Information label on the driver side center pillar. The 2020 manual specifications do not list a psi figure, so we have not printed one here.
Keep reading
The source entries were last checked against the 2020 owner's manual on 2026-10-23. Your trim and model year can differ, so confirm in your own owner's manual and on the tire placard before you buy or torque anything.