The Ford Bronco, 6th generation (TG1): the manual prints no tire size for each trim. It lists these chain-compatible sizes: 255/70R16 and 255/75R17. Lug nut torque is 100 lb-ft (150 on the Raptor, see below). The manual gives no pressure number; it sends you to the door placard.
Ford's 2024 Bronco manual (edition date 202308) is stingy with tire numbers. It prints no tire size for any trim, no wheel size and no cold pressure. What it does give you is a lug nut torque of 100 lb-ft for every Bronco except the Raptor, 150 lb-ft for the Raptor, two tire sizes in its snow chain guidance (255/70R16 and 255/75R17), and a pointer to the tire label for pressure.
Ford Bronco specs, by the manual
| Spec | Value | Applies to | Source |
|---|---|---|---|
| Tire size | 255/70R16 | Named only as a size snow chains may be fitted to; the manual ties it to no trim, Raptor or otherwise. | p. 446 |
| Tire size | 255/75R17 | Also named only as a size snow chains may be fitted to, with no trim attached. | p. 446 |
| Cold pressure | On the placard, no number in the manual | The tire label on the B-pillar or the edge of the driver door, or the Safety Compliance Certification Label on the door hinge pillar, door-latch post or the door edge that meets the door-latch. | p. 447 |
| Lug nut torque | 100 lb-ft | M12 x 1.5 wheel nuts on every Bronco except the Raptor, printed as 100 lb.ft (135 Nm). The Raptor has its own section and its own figure. A footnote says the torque specifications are for nut and bolt threads free of dirt and rust, and to use only Ford's recommended replacement fasteners. | p. 468 |
| Spare | The manual describes swapping a flat for the spare tire and says to stow the flat on the rear of the vehicle. No spare size or pressure appears on the pages quoted here. | All | p. 463 |
| TPMS | Direct (sensors) | The manual says the tire pressure sensors are mounted in the wheels and are not designed to be used in aftermarket wheels. | p. 445 |
Compare this lug nut torque with other vehicles in the lug nut torque chart.
Compare this tire pressure with other vehicles in the tire pressure chart.
Compare these tire sizes with other vehicles in the tire size chart.
The 2024 Ford Bronco owner's manual does not print a wheel size, so this page lists none (p. 446).
Exceptions the manual documents
Bronco Raptor
The Raptor wheel nuts are M14 x 1.5 and the manual prints 150 lb.ft (204 Nm), under their own heading, with the same footnote about clean threads and recommended replacement fasteners. (p. 469)
Snow chains, all Broncos
Fit chains to the rear wheels only, in pairs, and not self-tensioning ones. If the vehicle is fitted with wheel trims, remove them before fitting chains. (p. 445)
Snow chain sizes, all Broncos
Only use chains on the specified tire sizes, 255/70R16 and 255/75R17, and only chains that are 15 mm or less. (p. 446)
Driving with snow chains
Do not exceed 30 mph (50 km/h), or the chain maker's limit if that is lower, and do not use chains on dry roads. (p. 446)
Temporary spare wheel mounted
Do not use snow chains on the axle with the temporary spare wheel. (p. 446)
Spare tire in use
The tire pressure monitoring indicator light illuminates when the spare tire is in use; the full function returns when all road wheels with sensors are mounted again. (p. 459)
Reading these numbers
The Raptor gets its own headings in this manual. The wheel nut pages are split into "Wheel Nuts - Excluding: Raptor", with M12 x 1.5 nuts at 100 lb-ft (135 Nm), and "Wheel Nuts - Raptor", with M14 x 1.5 nuts at 150 lb-ft (204 Nm). Both tell you to retighten to the specified torque within 100 mi (160 km) after any wheel disturbance, such as a rotation or a flat change. A footnote on each page says the torque specifications are for nut and bolt threads free of dirt and rust, and to use only Ford's recommended replacement fasteners. The flat tire instructions are split the same way. If you drive a Raptor, read the Raptor heading and ignore the other one.
For pressure, the manual does not print a number. It says to inflate to the recommended pressure even when that is below the maximum printed on the tire, and that the figure sits on the tire label on the B-pillar or the edge of the driver door, and on the Safety Compliance Certification Label. Read the label on your own truck.
Winter is where the fine print lives. The manual says chains go on the rear wheels only, in pairs, and not the self-tensioning kind, to take off any wheel trims first, and only on the specified tire sizes: 255/70R16 and 255/75R17, each with chains that are 15 mm or less. It also says to stay under 30 mph (50 km/h) or the chain maker's limit if that is lower, to keep chains off dry roads, and to keep them off the axle that has a temporary spare. The chain section never mentions the Raptor or any other trim, and it names no other size, so a Bronco on different tires has no chain guidance here.
On the wheel itself, Ford says the tire pressure sensors are mounted in the wheels and are not designed for aftermarket wheels, which matters if you shop for a second set. The sensor light also comes on while a spare is in use, and full function returns once every road wheel with a sensor is mounted again. This page follows the manual cited above; check your own owner's manual and door label for your truck.
Sources
Every number above is quoted from the documents below. Each source entry was last checked against its manual on 2026-10-27.
2024 Bronco Owner's Manual, Ford Motor Company (PDF copy hosted by pdf.amanuals.com), page 445
Edition date: 202308 (TG1, Canada/United States of America). Last checked against the manual on 2026-10-27.
"The tire pressure sensors mounted in the wheels (originally installed on your vehicle) are not designed to be used in aftermarket wheels. [...] USING SNOW CHAINS WARNING: Do not exceed 30 mph (50 km/h). [...] WARNING: Only fit snow chains to specified tires. WARNING: If your vehicle is fitted with wheel trims, remove them before fitting snow chains. [...] Only use snow chains on rear wheels. Install snow chains in pairs. Do not use self-tensioning snow chains. Only use snow chains on the following specified tire sizes:"
2024 Bronco Owner's Manual, Ford Motor Company (PDF copy hosted by pdf.amanuals.com), page 446
Edition date: 202308 (TG1, Canada/United States of America). Last checked against the manual on 2026-10-27.
"255/70R16 Only install chains that are 15 mm or less. 255/75R17 Only install chains that are 15 mm or less. We recommend you use steel wheels of the same size and specification if snow chains are required because chains may chip aluminum wheels. [...] When driving with snow chains do not exceed 30 mph (50 km/h) or the maximum speed recommended by the chain manufacturer, whichever is less. [...] Remove the snow chains when they are no longer needed. Do not use snow chains on dry roads. [...] If a temporary spare wheel is mounted on your vehicle, do not use snow chains on the axle with the temporary spare wheel. [...] 2024 Bronco (TG1) Canada/United States of America, enUSA, Edition date: 202308, DOM"
2024 Bronco Owner's Manual, Ford Motor Company (PDF copy hosted by pdf.amanuals.com), page 447
Edition date: 202308 (TG1, Canada/United States of America). Last checked against the manual on 2026-10-27.
"Inflate your tires to the recommended inflation pressure even if it is less than the maximum inflation pressure information found on the tire. You can find the tire label with the recommended tire inflation pressure next to the tire size on the B-Pillar or the edge of the driver door. The recommended tire inflation pressure is also found on the Safety Compliance Certification Label, affixed to either the door hinge pillar, door-latch post, or the door edge that meets the door-latch on the B-pillar, or on the edge of the driver door."
2024 Bronco Owner's Manual, Ford Motor Company (PDF copy hosted by pdf.amanuals.com), page 459
Edition date: 202308 (TG1, Canada/United States of America). Last checked against the manual on 2026-10-27.
"CHANGING A FLAT TIRE - EXCLUDING: RAPTOR [...] Note: The tire pressure monitoring system indicator light illuminates when the spare tire is in use. To restore the full function of the monitoring system, all road wheels equipped with tire pressure monitoring sensors must be mounted on the vehicle."
2024 Bronco Owner's Manual, Ford Motor Company (PDF copy hosted by pdf.amanuals.com), page 463
Edition date: 202308 (TG1, Canada/United States of America). Last checked against the manual on 2026-10-27.
"Stow the flat tire on the rear of the vehicle and fully tighten the securing nuts. [...] CHANGING A FLAT TIRE - RAPTOR [...] Replace the spare tire with a road tire as soon as possible."
2024 Bronco Owner's Manual, Ford Motor Company (PDF copy hosted by pdf.amanuals.com), page 468
Edition date: 202308 (TG1, Canada/United States of America). Last checked against the manual on 2026-10-27.
"WHEEL NUTS - EXCLUDING: RAPTOR Wheel Nut Torque Specifications [...] M12 X 1.5 100 lb.ft (135 Nm) [...] * Torque specifications are for nut and bolt threads free of dirt and rust. Use only our recommended replacement fasteners. [...] Retighten the lug nuts to the specified torque within 100 mi (160 km) after any wheel disturbance (such as tire rotation, changing a flat tire, wheel removal)."
2024 Bronco Owner's Manual, Ford Motor Company (PDF copy hosted by pdf.amanuals.com), page 469
Edition date: 202308 (TG1, Canada/United States of America). Last checked against the manual on 2026-10-27.
"WHEEL NUTS - RAPTOR Wheel Nut Torque Specifications [...] M14 X 1.5 150 lb.ft (204 Nm) [...] * Torque specifications are for nut and bolt threads free of dirt and rust. Use only our recommended replacement fasteners. [...] Retighten the lug nuts to the specified torque within 100 mi (160 km) after any wheel disturbance, such as tire rotation, changing a flat tire or wheel removal."
Frequently asked
What size tires does a 2024 Ford Bronco take?
The manual does not list tire sizes by trim. The only sizes it prints are 255/70R16 and 255/75R17, in its snow chain guidance, and it does not say which Bronco wears which. Read the sidewall of your current tire and the tire label on the B-pillar.
What tire size is the Bronco Raptor?
The 2024 manual does not say. It covers the Raptor by name for lug nut torque and flat tire steps, but prints no Raptor tire size, and its chain section names no trim. Use the sidewall of the tires on the truck and the tire label.
What tire pressure does a Ford Bronco need?
No number is printed. Ford points to the tire label on the B-pillar or the edge of the driver door, and to the Safety Compliance Certification Label, for the recommended pressure.
What is the lug nut torque for a Ford Bronco?
For every Bronco except the Raptor the manual prints 100 lb.ft (135 Nm) on M12 x 1.5 wheel nuts. For the Raptor it prints 150 lb.ft (204 Nm) on M14 x 1.5 nuts. Retighten within 100 mi (160 km) after any wheel disturbance. A footnote says the figures apply to threads free of dirt and rust, with only Ford's recommended replacement fasteners.
Can you use snow chains on a Ford Bronco?
Only within limits. Ford says to use them on the rear wheels in pairs, never self-tensioning chains, with any wheel trims removed first, on the specified sizes 255/70R16 and 255/75R17 only, with chains 15 mm or less, and below 30 mph (50 km/h). Do not use them on the axle with a temporary spare.
What wheel size is a Ford Bronco?
The 2024 owner's manual does not print a wheel size, so this page lists none. Check the wheel itself or the label before you order wheels.
Keep reading
The source entries were last checked against the 2024 owner's manual on 2026-10-27. Your trim and model year can differ, so confirm in your own owner's manual and on the tire placard before you buy or torque anything.